The original hardware is based on three main boards:
- CTI-VMAX – ARM9 with Wi-Fi, Bluetooth, and Ethernet connectivity.
- ARM SCOPE v1.0.1 with 8 channel ADC.
- ARM SCOPE v1.0.2 with 4 high speed ADC (100MSPS).
The ELHEP researchers have been looking at replacing CTI-VMAX with low cost boards, and after considering several options, they chose to design two versions of their oscilloscope: one based on Cubieboard, and the other on the Beaglebone.
So they designed expansions boards for the Cubieboard and Beaglebone in order to connect the ARM SCOPEs.
This project involved hardware development, software development (Linux firmware in Beaglebone/Cubieboard, MMS protocol, and app development), and once everything is setup you can see the waveform on a mobile device as shown below.
Their mobile app first discovers the measurement equipment on the network (left), remotely configures the device (middle), and displays the waveform (right).
The researchers/students are still working on perfecting the project. You can find out more on
MMS Project page (in Polish).
Read more: http://www.cnx-software.com/tag/cubieboard/#ixzz2OcLLhLRS
原文作者：
matson 
发表于 2014-8-30 10:27:19
/5 
